Casting of Wax candles and Wax figures

  Put the candlewick in the centre of the bottom of the mould. Let approximately 2 cm of the wick stick out at the top...
  Turn the mould up right and put rubber bands on to make it really tight...
  Put the wick through the "wickholder". Be very exact about keeping the wick in the centre and really tight...
  When the wick has been cut above the wick holder, the mould is ready to be mould...
 

Pour the heated wax in the mould. The temperature of the wax should not exceed 75° (Celcius), or else it may shrink when cooled down...
  Loosen the candle. Make sure the mould has got cold before you remove the wick holder and the rubber bands. Open the mould and behold your creation.
   
 
Phone +46 (0)506-102 73 Fax +46 (0)506-100 04 E-mail info@biredskapsfabriken.se
© MS Biredskapsfabriken AB. All rights reserved.